AIoT-i350-EVK
This evaluation kit is available to our technology partners to evaluate the MT8365 processor for solution design and development.
Board Feature Summary
At the current release, AIoT Yocto enables the following board features:
Supported Board Features
MediaTek MT8365 SoC
MediaTek PMIC (MT6357)
3GB LPDDR4 RAM x 1 (Micron MT53E768M32D4DT-053)
64GB eMMC x 1 (SanDisk/Western Digital SDINBDA4_64G)
2.0mm DC Jack x 1 (for 12V DC Input)
Micro SD Card Slot x 1
Push Button x 4 (Power, Reset, Volume-Up and Volume-Down)
4-Lane DSI x 1
HDMI x 1
10/100 Ethernet x 1 (Shared with DPI Signal)
USB Device Port x 1 (Micro USB Connector)
USB Host Port x 1 (Type-A USB Connector)
3.5mm Earphone Jack x 1 (with Microphone Input)
3.5mm Line Out Audio Jack x 1
Analog Microphone x 1
Digital Microphone x 2
UART Port x 2 for Trace Log with USB to UART Bridge IC (Micro USB Connector x 2)
I2C Capacitive Touch Pad
4-Data Lane CSI x 2 (SAS SFF-8087 Connector)
M.2 Slot x 1 (for AzureWave AW-CB451NF WiFi Module)
40-Pin 2.54mm Pin Header x 1 (for Raspberry Pi like I/O Interface)
Unsupported Board Features
3-bit DIP Switch for Boot ID
2-Pin 2.54mm Jumper (for IrDA Receiver)
Battery Charger
MT6631 Bluetooth/Wi-Fi/GPS/FM
SPDIF In/Out
Bluetooth function on AzureWave AW-CB451NF is not supported
Important
AIoT Yocto does NOT provide official support for Bluetooth functionality on MT7663. Only the Wi-Fi connectivity features are supported.
FTDI board control
The AIoT-i350-EVK has two FTDI chips connected to the UART0 (CON461) port and to the UART1 (CON462) port. They are both able to control the power (PWRKEY), reset (SYSRST), and download (KPCOL0) lines.
FTDI GPIO Line |
Function |
---|---|
0 |
Power (PWRKEY) |
1 |
Reset (SYSRST) |
2 |
Download (KPCOL0) |