.. include:: /keyword.rst ========== |G510-EVK| ========== |G510-EVK| board is an evaluation kit of MediaTek :doc:`MT8370 ` platform, which is a high performance IoT platform with rich features. This section describes board features that are relevant to |IOT-YOCTO|. For details on EVK features, please download **Genio 510 (MT8370) EVK User Guide** from https://www.mediatek.com/iot/documents. .. list-table:: |G510-EVK| :widths: 45 45 :header-rows: 0 :align: center * - .. figure:: /_asset/hw_evk_g510-evk_isometric.jpg :height: 320px :align: center - .. figure:: /_asset/hw_evk_g510-evk_top-view.jpg :height: 320px :align: center |G510-EVK| Ports ================ .. _board-top-view-g510-evk: .. figure:: /_asset/hw_evk_g510-evk_ports.png :alt: Ports of |G510-EVK| main board :align: center :width: 65% Ports of |G510-EVK| main board .. figure:: /_asset/hw_evk_g510-evk_ports-btm.png :alt: Ports of |G510-EVK-REF-BOARD| main board :align: center :width: 65% Ports on the bottom side of |G510-EVK-REF-BOARD| main board Board Feature Summary ===================== At the current release, |IOT-YOCTO| enables the following board features: Supported Board Features ------------------------ * MediaTek CPU (MT8370) * MediaTek PMIC (MT6365) * 4GB LPDDR4X RAM (Micron MT53E1G32D2FW-046 IT: B) * 64GB eMMC5.1 x 1 (KIOXIA THGBMJG9C8LBAU8) * 2.0mm DC Jack x 1 (for 12V DC Input) * Micro SD Card Slot x 1 * Push Button x 4 (Power, Reset, Download and Home Key) * LEDs (Power, Reset, System on LED) * 4-Lane DSI x 2 (Only DSI0 supported) * eDP x 1 * HDMI2.0 x 1 * 10/100/1000M Ethernet x 1 * USB Device Port x 1 (Micro USB Connector) * USB Host Port x 1 (Type-C USB Connector) * 3.5mm Earphone Jack x 1 (with Microphone Input) * 3.5mm Line Out Audio Jack x 1 * Analog Microphone x 1 * Digital Microphone x 2 * UART Port x 3 for Trace Log with USB to UART Bridge IC (Micro USB Connector x 3) * I2C Capacitive Touch Pad * 4-Data Lane CSI x 2 * M.2 Slot x 1 (PCIe & USB) * AzureWave AW-XB468NF WiFi Module (MT7921) * M.2 Slot x 1 (SDIO) * 40-Pin 2.54mm Pin Header x 1 (for Raspberry Pi like I/O Interface) Unsupported Board Features -------------------------- * Charging Status LED * Battery Charger * AW-CB451NF WiFi Module (MT7663) * DSI1 (Only DSI0 supported) Please refer to :doc:`/sw/yocto/releases` section for detailed list on supported features. FTDI board control ================== The |G510-EVK| has a FTDI FT232R chip connected to the UART0 (`CN3200`) port. You can control the power (PWRKEY), reset (SYSRST), and download (KPCOL0) lines through the CBUS lines of the FT232R chip: .. csv-table:: :header: "FTDI GPIO Line", "Function" :widths: 10, 20 "0", "Power (PWRKEY)" "1", "Reset (SYSRST)" "2", "Download (KPCOL0)"