.. include:: /keyword.rst =========== |G1200-EVK| =========== .. contents:: General :local: :depth: 1 .. toctree:: :hidden: -------------------------------- This chapter describes platform-dependent information and instructions. For example, you will get different benchmark results on different platforms. For general usage of Wi-Fi, such as command to configure DHCP or static IP and so on, please refer to :doc:`Wi-Fi ` chapter. .. note:: Command operations and test results presented in this chapter are based on the IoT Yocto v23.0 and |G1200-EVK-REF-BOARD|. -------------------------------- .. contents:: Sections :local: :depth: 2 .. _Wi-Fi Wireless Interface on Genio 1200-EVK: Wireless Interface on Genio 1200-EVK ==================================== The wireless (Wi-Fi and Bluetooth combo) card should be connect to PCIe interface (M.2 slot) on Genio 1200-EVK: .. figure:: /_asset/sw_yocto_app-dev_wireless_port_g1200-evk.png :width: 80% :align: center Wireless Interface on Genio 1200-EVK .. _Wi-Fi Install Wireless Card on Genio 1200-EVK: Install Wireless Card on Genio 1200-EVK ======================================= The MT7921L M.2 PCIe card supports WiFi6. .. important:: |IOT-YOCTO| - Genio 1200-EVK only supports **MT7921L** modules by default. Module **AW-XB468NF** is used in this installation guide. You can find more configuration details in :ref:`MT7921 Module`. If you want to connect the MT7663 or MT7921S modules to the Genio 1200-EVK, certain modifications to the PCB are required. This topic is beyond the scope of this document. For further assistance, please contact MediaTek's Customer Project Manager (CPM). There is a M.2 PCIe slot on Genio 1200-EVK board. It is reserved for wireless card. In the picture below, you can find 2 cables connect to the antennas on MT7921 card. These cables use I-PEX MHF4 (IPEX4) connectors. .. figure:: /_asset/sw_yocto_app-dev_wireless-install-wireless-card-MT7921_g1200-EVK.png :width: 80% :align: center A MT7921L M.2 PCIe Module is Installed on Genio 1200-EVK. If you don't have I-PEX MHF4 cable and antennas, please buy a set and attach them to MT7921. Even a pair of 2db antennas will improve signal quality a lot. This is necessary to get good signal quality. .. note:: Interface name in Linux OS may be different by modules. It should be **wlp1s0** for MT7921L PCIe module.