.. include:: /keyword.rst .. _soc-mt8365: ================== MT8365 (Genio 350) ================== The MT8365 is a highly integrated solution for connected multimedia systems. Currently most of hardware features are supported by |IOT-YOCTO|, while others are only supported by MediaTek proprietary software. Please refer to the functional block diagram below for the hardware features that |IOT-YOCTO| supports. .. figure:: /_asset/hw_soc_g350_block.svg :align: center :width: 800px MediaTek MT8365 functional block and |IOT-YOCTO| enablement status Supported Functional Blocks =========================== For an overview of hardware capabilities of MT8365, please visit `IoT Developer Home page `_. At current release, |IOT-YOCTO| supports the following MT8365 device features: * Quad-core Arm® Cortex®-A53 64-bit processor * Arm Mali™-G52 MC1 3D Graphics Accelerator (GPU) * AI Processor Unit (APU) Cadence® Tensilica® VP6 processor * Dual MIPI® Camera Serial Interface (CSI) * Dual display support with MIPI DSI and DPI * Rich audio interfaces to support various microphones and speakers configurations * 10/100 Ethernet MAC with RMII * Support Wi-Fi connectivity through external MT7663 SDIO module .. important:: IoT Yocto only provide proprietary BlueDroid stacks on MT7663. Unsupported Function and Features ================================= The following MT8365 device features are **not available** on |IOT-YOCTO|: * Image Signal Processor (ISP) * Face Detection 5.0 (FD) * Warp Engine (WPE) * Built-In Wi-Fi®/Bluetooth®, GNSS, and FM Radio connectivity * Cadence HiFi 4 Audio Engine DSP * Display support with LVDS * JPEG Encoder * Time Division Multiplexed Interface (TDM) * Sony/Philips Digital Interface (S/PDIF) * MII Ethernet MAC * NAND flash interface .. note:: |IOT-YOCTO| does not support the built-in wireless connectivity features of MT8365 and the companion chip MT6631. Instead, an external MT7663 SDIO wireless module is used on |i350-EVK-REF-BOARD| to provide wireless connectivity. MT8365 Documentation ==================== Please visit `IoT Developer Home page `_ for hardware documentation.