.. include:: /keyword.rst ========== |G510-EVK| ========== |G510-EVK| board is an evaluation kit of MediaTek :doc:`MT8370 ` platform, which is a high performance IoT platform with rich features. This section describes board features that are relevant to |IOT-YOCTO|. Documentation ============= For |G510-EVK| hardware documentation and the EVK User Guide, please visit the `IoT Developer Home page `_. .. list-table:: |G510-EVK| :widths: 45 45 :header-rows: 0 :align: center * - .. figure:: /_asset/hw_evk_g510-evk_isometric.jpg :height: 320px :align: center - .. figure:: /_asset/hw_evk_g510-evk_top-view.jpg :height: 320px :align: center |G510-EVK| Ports ================ .. _board-top-view-g510-evk: .. figure:: /_asset/hw_evk_g510-evk_ports.png :alt: Ports of |G510-EVK| main board :align: center :width: 65% Ports of |G510-EVK| main board .. figure:: /_asset/hw_evk_g510-evk_ports-btm.png :alt: Ports of |G510-EVK-REF-BOARD| main board :align: center :width: 65% Ports on the bottom side of |G510-EVK-REF-BOARD| main board Block Diagram ============= .. figure:: /_asset/510-qsg/G510_block_diagram_with_RichTek.png :align: center :width: 1000px Block Diagram Packing List ^^^^^^^^^^^^ ===== ======================== ============================== =============================== ========= S.No Part Number or Marking Item Name Description Quantity ===== ======================== ============================== =============================== ========= 1 IoT-Genio 510 EVK-P1V3 Genio 510 EVK main motherboard 1 2 IoT-CAM-DTB-D1V2-D2 D2 Camera Board Smaller Raw Sensor Camera Board 1 using IMX214 Image Sensor (not used in this QSG) 3 KD070FHFID015-C021A 7" LCD Panel LCM Module 1 4 M.2 WIFI6 Module WiFi Module Installed 1 AW-XB468NF (IC: MT7921L) 5 IPEX to IPEX cable Installed 2 6 SMA Antenna WiFi Antenna Installed 1 7 12V, 4.16A AC adapter 1 plus power cord ===== ======================== ============================== =============================== ========= Description of kit contents ^^^^^^^^^^^^^^^^^^^^^^^^^^^ Genio 510 EVK Main Motherboard ------------------------------ These images show the main motherboard and relevant IO. .. figure:: /_asset/510-qsg/hw_evk_g510-evk_ports.png :align: center :width: 500px Genio 510-EVK Top View Main Motherboard .. figure:: /_asset/510-qsg/hw_evk_g510-evk_ports-btm.png :align: center :width: 500px Genio 510-EVK Bottom View Main Motherboard D6 Camera Board --------------- The D6 camera Board uses the ON Semiconductor AR0830 sensor. The board has two MIPI CSI paths, one connecting directly with the processor (MT837 0) on the main motherboard, and another connecting with the main motherboard through an ISP (On-Semiconductor AP1302CSSL00SMGA0-DR). These two MIPI paths are switched by a MIPI multiplexer (TI TS3DV642RUARQ1). .. figure:: /_asset/510-qsg/d6_camera_board.jpg :align: center :width: 500px D6 Camera Board Board Feature Summary ===================== At the current release, |IOT-YOCTO| enables the following board features: Supported Board Features ^^^^^^^^^^^^^^^^^^^^^^^^ * MediaTek CPU (MT8370) * MediaTek PMIC (MT6365) * 4GB LPDDR4X RAM (Micron MT53E1G32D2FW-046 IT: B) * 64GB eMMC5.1 x 1 (KIOXIA THGBMJG9C8LBAU8) * 2.0mm DC Jack x 1 (for 12V DC Input) * Micro SD Card Slot x 1 * Push Button x 4 (Power, Reset, Download and Home Key) * LEDs (Power, Reset, System on LED) * 4-Lane DSI x 2 (Only DSI0 supported) * eDP x 1 * HDMI2.0 x 1 * 10/100/1000M Ethernet x 1 * USB Device Port x 1 (Micro USB Connector) * USB Host Port x 1 (Type-C USB Connector) * 3.5mm Earphone Jack x 1 (with Microphone Input) * 3.5mm Line Out Audio Jack x 1 * Analog Microphone x 1 * Digital Microphone x 2 * UART Port x 3 for Trace Log with USB to UART Bridge IC (Micro USB Connector x 3) * I2C Capacitive Touch Pad * 4-Data Lane CSI x 2 * M.2 Slot x 1 (PCIe & USB) * AzureWave AW-XB468NF WiFi Module (MT7921) * M.2 Slot x 1 (SDIO) * 40-Pin 2.54mm Pin Header x 1 (for Raspberry Pi like I/O Interface) Unsupported Board Features ^^^^^^^^^^^^^^^^^^^^^^^^^^ * Charging Status LED * Battery Charger * AW-CB451NF WiFi Module (MT7663) * DSI1 (Only DSI0 supported) Please refer to :doc:`/sw/yocto/releases` section for detailed list on supported features. FTDI board control ================== The |G510-EVK| has a FTDI FT232R chip connected to the UART0 (`CN3200`) port. You can control the power (PWRKEY), reset (SYSRST), and download (KPCOL0) lines through the CBUS lines of the FT232R chip: .. csv-table:: :header: "FTDI GPIO Line", "Function" :widths: 10, 20 "0", "Power (PWRKEY)" "1", "Reset (SYSRST)" "2", "Download (KPCOL0)"